| Step | | Procedure & Parts & Tools |
| 1 |
|
TURN KEY TO TURN OFF POWER TO MACHINE
|
| 2 |
|
LOCATE CHARGER PLUG ON BACK OF MACHINE AND PULL IT TO DISCONNECT THE BATTERIES
|
| 3 |
|
LOCATE THE DRAIN HOSES ON THE BACK OF THE MACHINE.
|
| 4 |
|
PULL TO REMOVE THE BLUE CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 5 |
|
PULL TO REMOVE THE RED CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 6 |
|
REMOVE THE 2 TANK BOLTS ON EACH SIDE OF THE MACHINE. THESE BOLTS ARE LOCATED AT THE FRONT OF THE MACHINE AT THE BASE.
| Wrench-Allen metric 6.0mm |
|
|
| 7 |
|
LIFT THE TANK TO OPEN THE MACHINE
|
| 8 |
|
DISCONNECT THE BATTERY CABLES AND REMOVE THE 2 BATTERIES FROM THE MACHINE.
| Wrench-metric 10mm |
|
| Wrench-metric 13mm |
|
|
| 9 |
|
REMOVE THE 2 BOLTS HOLDING THE BRUSH SHROUD
| Wrench-Allen metric 6.0mm |
|
|
| 10 |
|
LAY THE MACHINE ON ITS SIDE.
|
| 11 |
|
REMOVE THE 3 SCREWS FROM THE COVER
| Wrench-Allen metric 6.0mm |
|
|
| 12 |
|
PULL TO REMOVE THE COVER
|
| 13 |
|
TURN THE BRUSH PULLEY TO CHECK FOR LOCKED UP CONDITION. IF THE BRUSH PULLEY TURNS FREELY, IT IS NOT LOCKED UP.
|
| 14 |
|
IF THE BRUSH PULLEY IS OKAY, REVERSE STEPS 6 THRU 12 TO REASSEMBLE THE MACHINE. RECONNECT THE CHARGER PLUG. RECONNECT THE BATTERY CABLES USING THE DIAGRAM SHOWN HERE.
|